
32 | Replacing the Touchscreen Board
Replacing the Touchscreen Board
WARNING:
B
efore working inside your computer, read the safety information
that shipped with your computer and follow the steps in "Before You Begin" on
page 9. After working inside your computer, follow the instructions in
"After Working Inside Your Computer" on page 11. For additional safety best
practices information, see the Regulatory Compliance Homepage at
dell.com/regulatory_compliance.
Procedure
1 Align the screw holes on the touchscreen board with the screw holes on the
chassis.
2 Replace the screws that secure the touchscreen board to the chassis.
3 Connect the touchscreen-board cable to the connector on the touchscreen board.
4 Slide the display cable and touchscreen cable into the connectors on the
touchscreen board and press down on the connector latches to secure the cables.
5 Slide the tab on the touchscreen-board cover into the slot on the chassis and align
the screw hole on the touchscreen-board cover with the screw hole on
the chassis.
6 Replace the screw that secures the touchscreen-board cover to the chassis.
Postrequisites
1 Replace the back cover. See "Replacing the Back Cover" on page 20.
2 Replace the stand. See "Replacing the Stand" on page 18.
3 Replace the stand cover. See "Replacing the Stand Cover" on page 16.
4 Follow the instructions in "After Working Inside Your Computer" on page 11.
book.book Page 32 Thursday, April 11, 2013 12:21 PM
Comments to this Manuals