Dell PowerEdge 2650 User Manual download pdf (Page 7)

Microprocessor Upgrade Installation Guide 1-5

Figure 1-2. Installing a VRM

Replace the cooling shroud, if applicable (see your Installation and Troubleshooting

Guide).

16 Close the system doors, or replace the system cover (see your Installation and

Troubleshooting Guide).

17 Reconnect your system and peripherals to their electrical outlets, and turn them on.

As the system boots, it detects the presence of the new processor and automatically

changes the system configuration information in the System Setup program.

NOTE: After you access the inside of the system, the chassis intrusion detector will cause

an alert message to be displayed at the next system startup. This message is stored in the

system’s nonvolatile random-access memory (NVRAM). To clear this message log, see your

systems management software documentation.

18 Enter the System Setup program and ensure that the microprocessor categories match

the new system configuration. For instructions about using the System Setup

program, see your User’s Guide.

19 Run the system diagnostics to verify that the new microprocessor is operating

correctly. See your Installation and Troubleshooting Guide for information about

running the diagnostics and troubleshooting any problems that may occur.

VRM

VRM connector

latches (2)

connector key

9D904ebk5.book Page 5 Wednesday, March 5, 2003 1:42 PM

1 2 3 4 5 6 7 8 ... 56

No comments

Dell PowerEdge 2650 User Manual Page 7