1. Follow the procedures in Before You Begin.
2. Disconnect the cooling fan power cable from the fan connector on the system board.
3. Disconnect the power cable from the processor power connector on the system board.
4. Lift up the airflow shroud.
5. Remove the microprocessor heat sink:
a. Twist the heat sink from side to side to break the seal.
b. Pull the release tab out until the heat sink is released.
c. Lift the heat sink away from the microprocessor.
d. On the retention base, locate the tab opposite the power supply. Press on the retention base tab until the heat sink pops up slightly.
e. Press out on the second retention tab while lifting the heat sink up and out of the retention base.
6. Push down and out on the socket release lever.
7. Open the processor cover.
NOTICE: If you are installing a processor upgrade kit from Dell, discard the original heat sink. If you are not installing a processor upgrade kit from Dell,
reuse the original heat sink and blower when you install your new processor.
Comments to this Manuals