Dell Precision 620 User Manual download pdf (Page 10)

of the bracket should be flush with the front of the drive (see Figure 13).

To further ensure proper positioning of the drive in the chassis, insert and tighten all four screws in the order in which the holes are

numbered (the holes are marked "1" through "4" on the bracket bottom).

7. Slide the new drive into the drive bay until the drive snaps securely into place (see Figure 13).

Make sure that both bracket tabs snap into place in the drive bay.

Figure 13. 5.25-Inch Drive Replacement

8. Connect a DC power cable to the power input connector on the back of the drive (see Figure 14).

9. Connect the appropriate interface cable to the interface connector on the back of the drive (see Figure 14).

If your system came with an EIDE CD-ROM or tape drive, use the spare connector on the existing interface cable. Otherwise, use the EIDE

interface cable provided in the drive kit.

NOTICE: If you are installing an EIDE drive, you must match the colored strip on the cable with pin 1 on the drive's interface

connector to avoid possible damage to your system.

Figure 14. Attaching Cables to 5.25-Inch Diskette Drives

10. For an EIDE tape drive or CD-ROM drive, connect the other end of the interface cable to the interface connector labeled "IDE2" on the

system board.

For a diskette drive, connect the cable from the drive to the interface connector labeled "DISKETTE" on the system board.

For a CD-ROM drive, reconnect the audio cable.

Check all cable connections. Fold cables out of the way to provide airflow for the fan and cooling vents.

11. If the 5.25-inch drive bay was previously empty, remove the front-panel insert from the front panel.

Drive

DC power cable

Power input connector

Interface connector

Interface cable

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 29 30

No comments

Dell Precision 620 User Manual Page 10