Dell GX1 User Manual download pdf (Page 103)

Installing System Board Options 6-7

NOTE: Installing filler brackets over empty card-slot openings is necessary to

maintain Federal Communications Commission (FCC) certification of the system.

The brackets also keep dust and dirt out of your computer.

 5HSODFHWKHH[SDQVLRQFDUGFDJHLQWKHFKDVVLVDVLQVWUXFW HGLQ

´ 5HSODFLQJWKH([ SDQVLRQ&DUG& DJHµ LQ&KDSWHU

 5HSODFHWKHFRPSXW HUFRYHUUHFRQQHFW\RXUFRP SXWHUDQ GSHULSKHUDOV

WRWKHLUSRZHUVRXUFHVDQGWXUQWKHPR Q

NOTE: After you remove and replace the cover, the chassis intrusion detector will

cause the following message to be displayed at the next system start-up:

ALERT! Cover was previously removed.

 7RUHVHWWKHFKDVVLVLQWUXVLRQGHWHFWRU HQWHUWKH6\VWHP6HWXSSURJUDP

DQGUHVHW&KDVVLV,QWUXVLRQWR1RW'HWHFWHG

See Chapter 2, “Using the System Setup Program,” for instructions.

NOTE: If a setup password has been assigned by someone else, contact your

network administrator for information on resetting the chassis intrusion detector.

$GGLQJ 0HPRU\

Memory can be increased to a maximum of 384 megabytes (MB) by installing combi-

nations of 32-, 64-, or 128-MB dual in-line memory modules (DIMMs) in the three

DIMM sockets on the system board. Figure 6-6 shows the DIMMs and DIMM

sockets.

Your system can support both error checking and correction (ECC) and nonparity syn-

chronous dynamic random-access memory (SDRAM) DIMMs. However, ECC support

is available only if all DIMMs are ECC DIMMs. ECC DIMMs enable your system to

correct all single-bit memory errors and detect multibit memory errors.

)LJXUH',00VDQG',006RFNHWV

DIMMs (3)

DIMM

sockets

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 173 174

No comments

Dell GX1 User Manual Page 103