Dell POWEREDGE 300 User Manual download pdf (Page 38)

36 Two-Post Rack Installation

Installing Chassis Static Rail Modules

NOTE: You do not need to remove the optional front bezel to install or remove the chassis static rail modules

from the chassis.

To install a rail module, locate the three keyhole slots on the rail module and the corresponding

shoulder screws on the side of the system (see Figure 2-7).

Place the rail module against the side of the system so that the shoulder screws fit through the round

portion of the keyhole slots, then slide the module towards the back of the system.

Repeat steps 1 and 2 to install the other rail module.

To remove a

rail module

from the chassis, pull up on the release latch, then slide the rail forward and

remove the rail module from the chassis.

Figure 2-7. Installing and Removing Static Rail Chassis Modules

1 keyhole slots (6) 2 shoulder screws (6) 3 release latch

4 rail modules (2) 5 system

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 201 202

No comments

Dell POWEREDGE 300 User Manual Page 38