Dell POWEREDGE M915 User Manual download pdf (Page 23)

Information Update 23

Removing a Hard Drive

NOTE: Not all operating systems support hot-plug drive installation. See the

documentation supplied with your operating system.

Take the hard drive offline and wait until the hard-drive indicator codes

on the drive carrier signal that the drive may be removed safely.

When all indicators are off, the drive is ready for removal.

See your operating system documentation for more information on taking

the hard drive offline.

Open the hard-drive carrier handle to release the drive. See Figure 1-4.

Slide the hard drive out until it is free of the drive bay.

If you are permanently removing the hard drive, install a blank insert.

Shutdown Procedure for Servicing a Hard Drive

NOTE: This section applies only to situations where the blade must be powered

down to service a hard drive. In many situations, the hard drive can be serviced

while the blade is powered on.

If you need to power off the blade to service a hard drive, wait 30 seconds

after the blade’s power indicator turns off before removing the hard drive.

Otherwise, the hard drive may not be recognized after the hard drive is

reinstalled and the blade is powered on again.

Configuring the Boot Drive

The drive or device from which the system boots is determined by the boot

order specified in the System Setup program. See "Using the System Setup

Program and UEFI Boot Manager" in the Hardware Owner’s Manual.

Removing a Hard Drive From a Hard-Drive Carrier

CAUTION: Always wear a wrist grounding strap when handling equipment

with static-sensitive components.

If you are replacing a drive in the carrier, remove the four screws from the slide

rails on the hard-drive carrier and separate the hard drive from the carrier.

See Figure 1-5.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 185 186

No comments

Dell POWEREDGE M915 User Manual Page 23