Dell E6440 + Port Replicator Owner's Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 69
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
Installing the Base Corner Caps
1. Place the left and right base corner caps to align with the screw holes on the computer.
2. Tighten the screws to secure the base corner caps to the computer.
3. Install:
a) base cover
b) battery
4. Follow the procedures in
After Working Inside Your Computer
.
Removing the Network Connector
1. Follow the procedures in
Before Working Inside Your Computer
.
2. Remove:
a) battery
b) base cover
c) base corner cap (left)
3. Perform the following steps as shown in the illustration:
a) Disconnect the cable from the system board [1].
b) Release cable from the routing channel [2].
c) Remove the screw that secures the network-connector bracket to the computer.
4. Remove the network-connector bracket from the computer. Lift the network connector from the computer.
22
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 68 69

Comments to this Manuals

No comments