Dell Inspiron 2000 User Manual download pdf (Page 13)

The drive access indicator does not blink when data is being accessed from the diskette drive connected to the parallel connector.

NOTICE: Protect the diskette drive when it is not in the external media bay. Do not squeeze the drive or place objects on top of it;

doing so could damage the drive motor.

External Monitor

You can use the 15-pin video connector to attach an external monitor to the computer.

Connecting an External Monitor

To attach an external monitor, perform the following steps.

NOTICE:Donotplacethemonitordirectlyontopofyourportablecomputer,evenifitisclosed.Doingsocancrackthecomputer

case, the display, or both.

1. Make sure that the external monitor is turned off. Set the monitor on a monitor stand, desk top, or other level surface near your computer.

2. Connect the external monitor's video cable to the computer.

Plug the video cable connector into the matching video connector on the back of the computer. If the video cable is not permanently

attached to the monitor, connect it to the monitor.

Be sure to tighten all the screws on the video cable connector(s) to eliminate radio frequency interference (RFI).

3. Connect your external monitor to a grounded electrical outlet.

Plug the three-prong connector on one end of the monitor's power cable into a grounded power strip or some other grounded power

source. If the cable is not permanently attached to the monitor, connect it to the monitor.

Using an External Monitor

When an external monitor is connected to the computer, the video image automatically appears on the external monitor's screen when you boot

your computer.

To toggle the video image between the display, an external monitor, or both simultaneously, press <Fn><F8> on the keyboard. Press <Scroll

Lock><F8> on an external keyboard if the External Hot-Key option is enabled in the system setup program.

If the external monitor is turned off when you boot your computer, the computer still sends the video image to the external monitor, but you will not

see an image on either the computer's display or the external monitor. To see an image, turn on the external monitor or switch the video image to

the computer’s display by pressing <Fn><F8> on the keyboard or <Scroll Lock><F8> on an external keyboard if the External Hot-Key option is

enabled in the system setup program.

AC Adapter

You can attach the AC adapter to the computer by using the AC adapter connector. The AC adapter converts AC power to the DC power required

by the computer.

You can connect the AC adapter with your computer turned either on or off.

The AC adapter works with electrical outlets worldwide. However, power connectors vary among countries. Before using AC power in a foreign

country, you may need to obtain a new power cable designed for use in that country.

Audio Devices

You can connect audio devices such as speakers, microphones, and headphones to the two audio jacks, as follows:

l Connect the audio cable from a microphone to the microphone jack, also called the MIC IN jack.

l Connect the audio cable from speakers to the headphones/speakers jack, also called the line-out/speaker-out jack.

NOTE: If you are using the Microsoft Windows 98 operating system, you can use an external monitor as an extension of your

display. For more information, see the Windows 98 documentation or Dual-Display Mode.

NOTE: If you are using your external monitor at a resolution greater than the display supports, the simultaneous display feature is

disabled. To use the display, switch to a resolution that the computer supports, or disconnect the external monitor and restart your

computer.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 66 67

No comments

Dell Inspiron 2000 User Manual Page 13