Dell Inspiron M5010 Setup Guide Page 16

  • Download
  • Add to my manuals
  • Print
  • Page
    / 51
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 15
Back to Contents Page
Processor Heat Sink
Dell™Inspiron™N5010/M5010ServiceManual
Removing the Processor Heat Sink
Replacing the Processor Heat Sink
Removing the Processor Heat Sink
1. Follow the instructions in Before You Begin.
2. Remove the battery (see Removing the Battery).
3. Follow the instructions from step 3 to step 14 in Removing the System Board.
4. Disconnect the fan cable from the connector on the system board.
5. In sequential order (indicated on the processor heat sink), loosen the four captive screws that secure the processor heat sink to the system board.
6. Lift the processor heat sink off the system board.
Replacing the Processor Heat Sink
1. Follow the instructions in Before You Begin.
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
WARNING: If you remove the processor heat sink from the computer when the heat sink is hot, do not touch the metal housing of the processor
heat sink.
CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™
is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal
surface (such as a connector on your computer).
CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the
computer.
NOTE: The appearance and number of screws on the processor heat sink may vary based on the your computer model.
1
fan cable connector
2
processor heat sink
3
captive screws (4)
NOTE: This procedure assumes that you have already removed the processor heat sink and are ready to replace it.
Page view 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 50 51

Comments to this Manuals

No comments