Dell PowerConnect M6220 User Manual download pdf (Page 16)

X-Series Appliance Switch Configuration for v7.8.4  14

8. If you selected option 1:

a. You are prompted to configure VLAN settings for one or more blades.

To start, enter the blade number or numbers in a comma-separated list (1,2,3),

range format (1-3), or a combination (1,2, 5-8).

• All of the selected blades will receive traffic for the same VLAN or

VLANs.

• After configuring the first blade or set of blades, you will be given the

option to configure additional sets of VLAN settings for your remaining

blades.

b. Enter the VLAN ID or IDs to configure the traffic that will be directed to the

selected blades. VLAN IDs can be entered in a comma-separated list (100-

102), range format (100,101), or a combination.

Each blade supports a maximum of 3 VLANs.

c. If you have additional blades to configure, enter yes, and repeat steps a and b.

When you are finished, enter no to continue with the next step.

d. Specify whether to perform a full factory reset before reconfiguring each

switch, then review the configuration settings displayed. There is no need to

perform a factory reset unless you know there is a problem with the switch

configuration.

9. If the new settings look correct, enter 1 to start the switch reconfiguration process.

Progress information is displayed as first switch A1, then switch A2, is

configured.

The switch reconfiguration process should take only a few minutes.

10. When the switch reconfiguration is complete, press any key to exit the switch

configuration tool.

If you have configured for VLAN support, ensure that your upstream switch is

configured to send VLAN traffic to the X10G, and then configure individual blades to

recognize VLAN traffic. See Configuring VLAN support on a blade, page 9, for

instructions.

Installing a new switch

If you must replace a switch:

1. Contact Websense Technical Support for assistance.

2. When replacing the switch make certain that it is fully seated in the chassis,

and that the switch lever is latched.

3. During the replacement procedure, ask the Technical Support specialist to

demonstrate that the new switch is functioning properly, per your switch

configuration requirements.

1 2 ... 11 12 13 14 15 16

No comments

Dell PowerConnect M6220 User Manual Page 16