Dell S4820T Specifications download pdf (Page 36)

30 Performing the Initial Configuration

To configure the enable secret password, follow this step:

Create a Port-based VLAN

The Default VLAN (VLAN 1) is part of the system startup configuration and

does not require configuration. To configure a port-based VLAN, you must

create the VLAN and then add physical interfaces or port channel (LAG)

interfaces to the VLAN.

To create a port-based VLAN, follow this step:

To view the configured VLANs, use the show vlan command in EXEC

Privilege mode.

Assign Interfaces to a VLAN

You can only assign interfaces in Layer 2 mode to a VLAN using the tagged and

untagged commands. To place an interface in Layer 2 mode, use the switchport

command.

You can designate Layer 2 interfaces as tagged or untagged. When you place an

interface in Layer 2 mode using the switchport command, the interface is

automatically designated untagged and placed in the Default VLAN.

Task Command Syntax Command Mode

Create a password to

access EXEC

Privilege mode.

enable [password | secret] [level level]

[encryption-type] password

CONFIGURATION

Task Command Syntax Command Mode

Configure a port-based VLAN (if the

vlan-id is different from the Default

VLAN ID) and enter INTERFACE

VLAN mode. After you create a

VLAN, you must assign interfaces in

Layer 2 mode to the VLAN to activate

the VLAN.

interface vlan vlan-id CONFIGURATION

1 2 ... 31 32 33 34 35 36 37 38 39

No comments

Dell S4820T Specifications Page 36