Dell Precision Workstation 350 Technical Information download pdf (Page 34)

Back to Contents Page

Microprocessor

DellPrecision™Workstation350ServiceManual



Removing the Microprocessor

1. Disconnect the cooling fan power cable from the FAN connector on the system board.

2. Disconnect the power cable from the 12VPOWER connector on the system board.

3. Lift up the airflow shroud.



4. Remove the microprocessor heat sink:

a. For each of the metal securing clips that secure the heat sink to the microprocessor, press down on the clip's latch to release it from the heat-

sink retention base. Then lift the clip away from the heat sink.

b. Lift the heat sink away from the microprocessor.



CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the System Information Guide.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 40

No comments

Dell Precision Workstation 350 Technical Information Page 34