Dell Precision Workstation 350 Technical Information download pdf (Page 40)

1. Transfer components from the existing system board to the replacement system board.

2. Remove the memory modules and install them on the replacement board.



3. Remove the heat-sink assembly and microprocessor from the existing system board and transfer them to the replacement system board.

4. Configure the settings of the replacement system board.

5. Set the jumpers on the replacement system board so they are identical to the ones on the existing board.



6. Orient the replacement board by aligning the notches on the bottom to the tabs on the computer floor.

7. Slide the board toward the back of the computer until it clicks into place.

8. Replace any components and cables that you removed from the system board.

Back to Contents Page



CAUTION: The microprocessor package and heat-sink assembly can get hot. To avoid burns, be sure that the package and assembly have had

sufficient time to cool before you touch them.

NOTE: Some components and connectors on the replacement system board may be in different locations from the corresponding connectors on the

existing system board.

1 2 ... 35 36 37 38 39 40

No comments

Dell Precision Workstation 350 Technical Information Page 40