Dell PowerEdge 2650 User Manual download pdf (Page 16)

1-12 2-Post Rack Installation

www.dell.com | support.dell.com

Installing the System in the Rack

CAUTION: Due to the size and weight of the system, never attempt to install the

system by yourself.

NOTE: The procedure for installing a system into a rack is identical for flush-mount

and center-mount slide assemblies.

Pull the slides out to their fully extended position.

CAUTION: Because of the size and weight of the system, never attempt to install

the system in the slide assemblies by yourself.

Lift the system into position (see Figure 1-6).

3 Place one hand on the front-bottom of the system and the other hand on the back-

bottom of the system.

4 Tilt the back of the system down while aligning the back shoulder screws on the sides

of the system with the back slots on the slide assemblies.

5 Engage the back shoulder screws into their slots.

6 Lower the front of the system, and engage the front and middle shoulder screws in

their slots (the middle slot is behind the yellow system release latch) (see Figure 1-6).

When all shoulder screws are properly seated, the yellow latch on each slide assembly

clicks and locks the system into the slide assembly.

7 Press up on the green slide release latch at the side of each slide to slide the system

completely into the rack (see Figure 1-6).

8 Push in and turn the captive thumbscrews on each side of the front chassis panel to

secure the system to the rack.

NOTE: Use the yellow system release latch whenever you wish to remove the system

from the slide assemblies.

Installing the Cable-Management Arm

NOTICE: The cable-management arm can only be installed on the right side of the

rack cabinet (as viewed from the back).

To install the cable-management arm on the system, perform the following steps:

1 Facing the back of the rack cabinet, locate the latch on the end of the slide assembly.

2 Push the tab on the back end of the cable-management arm into the latch on the end

of the slide assembly (see Figure 1-7).

The latch clicks when locked.

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Dell PowerEdge 2650 User Manual Page 16