Dell UCS-71 User's Guide download pdf (Page 25)

Hardware Installation 25

Hardware Installation

This chapter describes how to install the Dell™ PowerEdge™

RAID Controller (PERC) H200 and 6Gbps SAS HBA cards.

Installing the PERC H200 and 6Gbps SAS HBA

Cards

CAUTION: Many repairs may only be done by a certified service technician.

You should only perform troubleshooting and simple repairs as authorized in

your product documentation, or as directed by the online or telephone service and

support team. Damage due to servicing that is not authorized by Dell is not

covered by your warranty. Read and follow the safety instructions that came

with the product.

Unpack the PERC H200 card or 6Gbps SAS HBA and check for damage.

NOTE: Contact Dell if the controller is damaged.

Turn off the system and attached peripherals, and disconnect the system

from the electrical outlet. See your system’s

Hardware Owner’s Manual

or the

User’s Guide

for more information on power supplies.

Disconnect the system from the network and remove the cover of the

system. See your system’s

Hardware Owner’s Manual

or the

User’s Guide

for more information on opening the system.

Select an appropriate

PCI-E slot. If replacing a PERC H200 Adapter or

6Gbps SAS HBA, remove the blank filler bracket on the back of the

system aligned with the PCI-E slot you have selected.

NOTE: For more information about your system’s PCI-E slots, see your

system’s Hardware Owner’s Manual.

Align the controller to the P

CI-E

slot you have selected.

PERC H200.book Page 25 Tuesday, July 13, 2010 4:15 PM

1 ... 24 25 26 ... 92

No comments

Dell UCS-71 User's Guide Page 25