Dell OptiPlex 745 User's Guide Page 129

  • Download
  • Add to my manuals
  • Print
  • Page
    / 212
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 128
Power Cable Connectors
Connecting and Disconnecting Drive Cables
When connecting and disconnecting a SATA data cable, hold the cable by the black connector at each end. SATA interface connectors are keyed for correct
insertion; that is, a notch or a missing pin on one connector matches a tab or a filled-in hole on the other connector.
Hard Drive
Removing a Hard Drive
1. If you are replacing a hard drive that contains data you want to keep, back up your files before you begin this procedure.
2. Check the documentation for the drive to verify that it is configured for your computer.
3. Follow the procedures in Before You Begin.
4. Lay the computer on its side so that the system board is on the bottom of the inside of the computer.
5. Press in on the two blue securing tabs on each side of the drive and slide the drive up and out of the computer.
6. Lift the drive out of the computer, careful not to pull the cables still attached to it.
NOTICE: Inserting a cable incorrectly prevents the drive from operating and could damage the controller, the drive, or both.
1
power cable
2
power input connector
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the computer cover.
NOTICE: To avoid damage to the drive, do not set it on a hard surface. Instead, set the drive on a surface, such as a foam pad, that will sufficiently
cushion it.
NOTICE: Do not pull the drive out of the computer by the drive cables. Doing so may cause damage to cables and the cable connectors.
Page view 128
1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 211 212

Comments to this Manuals

No comments