Dell PowerEdge 750 Troubleshooting Guide download pdf (Page 63)

The interface cables for SATA hard drives are connected to the system board. See FigureA-3 for the location of the system board connectors.



The interface cables for SCSI hard drives are connected to a controller card.

4. Loosen the captive screw that secures the hard-drive carrier to the chassis. See Figure7-3.

Figure 7-3. Removing the Hard-Drive Carrier



5. Slide the hard-drive carrier backward and lift the carrier out of the chassis.

6. Using a #2 Phillips screwdriver, remove the four screws that secure the hard drive to the carrier and remove the drive from the carrier. See Figure7-4.

Figure 7-4. Removing the Hard Drive From the Drive Carrier



Installing a Hard Drive

1. Align the hard-drive mounting holes with the holes in the drive carrier.

2. Using a #2 Phillips screwdriver, install the four screws that secure the hard drive to the carrier. See Figure7-4.

3. Align the hard-drive carrier so that the tabs on the chassis slide into the notches in the carrier. See Figure7-3.

4. Slide the carrier forward until it stops.

5. Tighten the captive screw that secures the hard-drive carrier to the chassis.

6. Connect the power and interface cables to the new drive.



The interface cables for SATA hard drives are connected to the system board. See FigureA-3 for the location of the system board connectors.



The interface cables for SCSI hard drives are connected to a controller card.

7. Install the CD drive or optional diskette drive.

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 75 76

Comments to this Manuals

No comments

Dell PowerEdge 750 Troubleshooting Guide Page 63

Comments to this Manuals

Related products and manuals for Servers Dell PowerEdge 750