Dell PowerConnect W-Airwave 7.5 User Manual download pdf (Page 325)

Dell PowerConnect W-AirWave 7.5 | User Guide Setting Up Dell PowerConnect-W Instant in AirWave | 313

 A group called Acme is created.

 A top-level folder called Acme is created.

 Two sub-folders called Store1 and Store2 are created which will contain the IAPs.

Reset your IAP to factory default state and reboot the IAP. You will see that the IAP will create a new role

automatically with the name that you have used in option 43. It will append the name with ‘Admin’ so it becomes

“Acme Admin”.

Remaining Manual Admin Tasks in AirWave

Once the setup is complete, what remains is to enable the newly created role, verify the shared secret, and add the

device.

Enabling the IAP Role

As stated previously, new IAP devices can be added to AirWave automatically. The Admin will then complete the

following tasks.

1. Enable the newly created Admin User Role in AMP Setup > Roles, as shown in Figure 245.

Figure 245 Enable Admin User Roles in AMP Setup > Roles

2. In Groups > Template for the newly created group, verify the first Virtual Controller's auto-created template.

3. Evaluate, approve, or ignore incoming Virtual Controllers with a different top level Organization String and/or

Shared Secret in the APs/Devices > New list. Subsequent IAPs are auto-authorized if they have an

Organization/Shared Secret key that matches the Shared Secret key of any existing authorized Virtual

Controller in the top-level Organization String.

4. Set the initial Virtual Controller to Manage Read/Write mode and push the good configuration to the

subsequent IAPs.

5. Set up AirWave users to have access to specific folders, if desired.

Verifying the Shared Secret

After the role is enabled, the Dell PowerConnect W-Instant device will appear in the APs/Devices > New page,

the admin user should mouse over the value under the Type column to verify the device’s Shared Secret with

AirWave, as shown in Figure 246.

NOTE: NOTE: The auto-created template is most useful if the first Virtual Controller for the top-level Organization String is fully

configured on-site before it is pointed at AirWave in the Virtual Controller’s UI.

1 2 ... 320 321 322 323 324 325 326 327 328 329 330 ... 337 338

No comments

Dell PowerConnect W-Airwave 7.5 User Manual Page 325