Dell PowerEdge 2800 User's Guide download pdf (Page 16)

14 Tower-to-Rack and Rack-to-Tower Conversion Guide

www.dell.com | support.dell.com

Figure 1-6. Removing/Installing the Control Panel Assembly and Front Panel

Using a T-10 Torx driver, remove the 22 screws that secure the tower front panel to the drive

tray. See Figure 1-6.

Installing the Rack Front Panel and Control Panel Assembly

Install the rack front panel

Orient the system as shown in Figure 1-6.

Using a T-10 Torx driver, install the 22 screws (that came in your kit) that secure the rack

front panel to the drive tray.

NOTE: The control panel assembly’s LCD board and the I/O board are the same for both the tower and

rack systems. Only the carrier is different. When converting your tower system to a rack system, you must

remove the LCD board and the I/O board from the control panel assembly that you removed in step 2 of

"Removing the Control Panel Assembly and Tower Front Panel."

drive tray in

maintenance

position

control panel

assembly

control panel

cable clamp

screws (3)

T-10 Torx

screws (22)

front panel

Y1001bk0.book Page 14 Thursday, July 8, 2004 4:32 PM

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

No comments

Dell PowerEdge 2800 User's Guide Page 16