Dell PowerEdge 2800 User's Guide download pdf (Page 7)

Tower-to-Rack and Rack-to-Tower Conversion Guide 5

Safety Instructions

Use the following safety guidelines to ensure your own personal safety and to help protect your

server, storage system, or appliance from potential damage. For complete safety and regulatory

information, see your

System Information

document. Warranty information might be included

within this document or as a separate document.

Precautions for Rack-Mountable Products

Observe the following precautions for rack stability and safety. Also refer to the rack installation

documentation accompanying the system and the rack for specific warning and/or caution

statements and procedures.

Servers, storage systems, and appliances are considered to be components in a rack. Thus,

"component" refers to any server, storage system, or appliance, as well as to various peripherals or

supporting hardware.

CAUTION: Installing system components in a rack without the front and side stabilizers installed could

cause the rack to tip over, potentially resulting in bodily injury under certain circumstances. Therefore,

always install the stabilizers before installing components in the rack.

CAUTION: After installing system/components in a rack, never pull more than one component out of

the rack on its slide assemblies at one time. The weight of more than one extended component could

cause the rack to tip over and injure someone.

NOTE: Your system is safety-certified as a free-standing unit and as a component for use in a rack

cabinet using the customer rack kit when both the rack cabinet and rack kit were designed for your

system. The installation of your system and rack kit in any other rack cabinet has not been approved by

any safety agencies. It is your responsibility to have the final combination of system and rack kit in a

cabinet evaluated for suitability by a certified safety agency. The manufacturer disclaims all warranties

and liability in connection with such combinations.

• System rack kits are intended to be installed in an approved rack by trained service

technicians. If you install the kit in any other rack, be sure that the rack meets the

specifications.

CAUTION: Do not move large racks by yourself. Due to the height and weight of the rack, it is

recommended that a minimum of two people perform this task.

• Before working on the rack, make sure that the stabilizers are secured to the rack, extend to

the floor, and that the full weight of the rack rests on the floor. Install front and side stabilizers

on a single rack or front stabilizers for joined multiple racks before working on the rack.

• Always load the rack from the bottom up, and load the heaviest item in the rack first.

• Make sure that the rack is level and stable before extending a component from the rack.

• Use caution when pressing the component rail release latches and sliding a component into or

out of a rack; the slide rails can pinch your fingers.

• After a component is inserted into the rack, carefully extend the rail into a locking position,

and then slide the component into the rack.

Y1001bk0.book Page 5 Thursday, July 8, 2004 4:32 PM

1 2 3 4 5 6 7 8 ... 36

No comments

Dell PowerEdge 2800 User's Guide Page 7