Figure A-3. System Board Jumpers
Table A-1. System-Board Jumper Settings
System Board Connectors
TableA-2 lists the connectors and sockets located on the system board. See Figure8-1 for the location of these connectors and sockets.
Table A-2. System Board Connectors and Sockets
Reserved (do not change).
The configuration settings are retained at system boot.
The configuration settings are cleared at next system boot. (If the configuration settings become corrupted to the point
where the system will not boot, install the jumper plug and boot the system. Remove the jumper before restoring the
configuration information.)
The password feature is enabled.
The password feature is disabled.
NOTE: For the full name of an abbreviation or acronym used in this table, see "Abbreviations and Acronyms."
Hot-pluggable SCSI backplane board interface cable connector
Serial port connectors; sometimes referred to as COM1 and COM2
memory module socket for integrated RAID controller
Intrusion-alarm switch connectors
Comments to this Manuals