Dell PowerEdge R900 User Manual Page 8

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 7
6 Dell™ Rack Installation Guide
Make sure that the rack is level and stable before extending a component
from the rack.
Use caution when pressing the component rail release latches and sliding
a component into or out of a rack; the slide rails can pinch your fingers.
After a component is inserted into the rack, carefully extend the rail into
a locking position, and then slide the component into the rack.
Do not overload the AC power supply branch circuit that provides power
to the rack. The total rack load should not exceed 80 percent of the branch
circuit rating.
Ensure that proper airflow is provided to components in the rack.
Do not step on or stand on any system/component when servicing other
systems/components in a rack.
Installation Instructions
This installation guide provides instructions for trained service technicians
installing one or more systems in an open-frame relay rack or in a rack
cabinet. The RapidRails™ rack kit can be installed without tools in
manufacturer’s rack cabinets that have square holes; the VersaRails™ rack
kit can be installed in most industry-standard rack cabinets that have square
or round holes. The procedures for installing both RapidRails and VersaRails
rack kits are similar. One rack kit is required for each system installed in the
rack.
CAUTION: Do not install rack kit components designed for another system.
Use only the rack kit for your system. Using the rack kit for another system
may result in damage to the system and personal injury.
The RapidRails rack kit can be installed in most industry-standard rack
cabinets.
NOTICE: The RapidRails rack kit is intended to be installed by trained service
technicians in a rack that meets the specifications of American National
Standards Institute (ANSI)/Electronic Industries Association (EIA) standard
ANSI/EIA-310-D-92, International Electrotechnical Commission (IEC) 297, and
Deutsche Industrie Norm (DIN) 41494. One rack kit is required for each system
that is installed in a rack.
Page view 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 141 142

Comments to this Manuals

No comments