Dell PowerEdge SC1435 User Manual download pdf (Page 29)

Two-Post Rack Installation 27

Two-Post Rack Installation

The two-post rack kit is used to install a system in a two-post, open-frame relay rack, such as those

found in telecommunications equipment facilities. Both 7.62-cm or 15.24-cm (3-inch and 6-inch) wide

two-post racks with universal hole spacing or wide hole spacing are accommodated. You can install this

kit in a center-mount or a flush-mount configuration.

You must properly secure the two-post relay rack to the floor, the ceiling, or upper wall, and where

applicable, to adjacent racks, using floor and wall fasteners and bracing specified or approved by the

rack manufacturer or by industry standards. See the two-post rack manufacturer's documentation for

warnings before attempting this installation.

CAUTION: Do not attempt to install the system into a two-post, open-frame relay rack that has not been

securely anchored in place. Damage to the system and personal injury to yourself and to others may result.

Safety Instructions

Use the following safety guidelines to ensure your own personal safety and to help protect your system

and working environment from potential damage. For complete safety information, see the

Product

Information

Guide

SAFETY: Rack Mounting of Systems

Observe the following precautions for rack stability and safety. Also refer to the rack installation

documentation accompanying the system and the rack for specific caution statements and

procedures.

Systems are considered to be components in a rack. Thus, "component" refers to any system as well

as to various peripherals or supporting hardware.

CAUTION: After installing system/components in a rack, never pull more than one component out of the rack on its slide

assemblies at one time. The weight of more than one extended component could cause the rack to tip over and may result

in serious injury.

NOTE: Your system is safety-certified as a free-standing unit and as a component for use in a Dell rack

cabinet using the customer rack kit. The installation of your system and rack kit in any other rack cabinet has

not been approved by any safety agencies. It is your responsibility to ensure that the final combination of

system and rack complies with all applicable safety standards and local electric code requirements. Dell

disclaims all liability and warranties in connection with such combinations.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 201 202

No comments

Dell PowerEdge SC1435 User Manual Page 29