Dell PowerVault 220S (SCSI) User Manual download pdf (Page 14)

1-10 Rack Installation Guide

www.dell.com | support.dell.com

5 Using two 10-32 x 0.5 Phillips screws, secure the back mounting-bracket flange to the

back vertical rail.

6 Repeat steps 1 through 5 for the remaining mounting rail on the other side of the rack.

7 Ensure that the mounting rails are mounted at the same position on the vertical rails

on each side of the rack.

Installing the Tower-to-Rack Conversion Kit

NOTE: If you have a rack-only version of the system, skip this procedure and proceed to

“Installing the System in the Rack.”

CAUTION: Your system may be very large and heavy. To prevent personal injury,

do not attempt to move the system by yourself.

The tower-to-rack conversion kit includes a rack front panel with rack handles and

thumbscrews.

Removing the Bezel, Drives, Covers, and Front Panel

1 Shut down and turn off power to your system and disconnect your power and

peripheral cables.

2 To remove the bezel (see Figure 1-7):

a Using the system key, unlock the front bezel.

b Swing the bezel away and down from the system until it is perpendicular to the

system.

c Loosen the two thumbscrews that secure the bezel hinge to the front panel (see

Figure 1-7).

d Pull the bezel away and set it aside.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 109 110

No comments

Dell PowerVault 220S (SCSI) User Manual Page 14