Dell PowerVault 56F (16P Fibre Channel Switch) User Manual Page 113

  • Download
  • Add to my manuals
  • Print
  • Page
    / 172
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 112
support.dell.com Repair and Replacement 6-5
)"#.!
1. Inset the new fan assembly into the switchs front assembly cavity.
2. Tighten the four front thumb-screws.
$'0
Replacing the system board involves removing the switchs cover, removing the sys-
tem board, and installing the new system board.
0;,*<

9
#6 flat-head screwdriver
8
1. Remove all cabling attached to the front panel.
2. Remove all GBICs.
See Removing a GBIC Module found earlier in this chapter for instructions.
3. Disconnect the power supply connector(s).
4. Remove the system board module by loosening the captured screw located
between ports 7 and 9 and pulling the assembly out of the switch. See
Figure 6-5.
5. Remove the new system board from its antistatic bag and place the old system
board into the bag.
Page view 112
1 2 ... 108 109 110 111 112 113 114 115 116 117 118 ... 171 172

Comments to this Manuals

No comments