Dell PowerVault 56F (16P Fibre Channel Switch) User Manual download pdf (Page 62)

4-6 Installation and Troubleshooting Guide



Figure 4-1, Figure 4-2, and Figure 4-3 show examples of the configure command,

which is used to set some switch configuration parameters. This command may not

be executed on an enabled switch; you must first disable the switch using the

switchdisable command.

The configure command is navigated by entering a series of collapsible top-level

menus. Each menu divides up the various switch configuration parameters into logical

groupings, which include: fabric parameters, virtual channel parameters, arbitrated

loop parameters, and system service parameters.

Each top level menu and its associated submenus consist of a text prompt, a list of

acceptable values, and the current value (shown in brackets). The current value is

used in the absence of an entered value when a carriage return is the only input

($!!''

% 

Alias ID This is the multicast address and has the format of FFFB

where

is an odd number ranging from 01 to 31. This num-

ber is the name of the multicast group.

Creator The Fibre Channel address ID of the Nx_Port that created

this Alias group.

Creator Token The Alias token that has been provided to map to the Alias

group.

It consists of four subfields:

rb = Routing bits

type = Upper level application type

grptype = The alias group type (can only be 10 for

multicast)

qlfr = Alias Qualifier of the group

These subfields are delimited by a pair of square braces.

For more information about Alias Token, see the FC-PH-2

and

FC-GS-2 American National Standards Institute (ANSI) stan-

dards.

Member List A list of member address IDs, delimited by a pair of curly

braces.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 171 172

No comments

Dell PowerVault 56F (16P Fibre Channel Switch) User Manual Page 62