Dell UPS 500T User Manual download pdf (Page 49)

Additional UPS Features

Network Transient Protector

The network transient protector, shown in Figure 23, is located on the rear panel and has jacks labeled

IN and OUT. This feature accommodates a single RJ‐45 (10BaseT) network connector.

NOTE:

DO NOT connect any telephone or fax/modem equipment (RJ-11) to the UPS.

1 Connect the input connector of the equipment you are protecting to the jack labeled IN.

2 Connect the network cable to the jack labeled OUT.

OUT IN

OUT

500–1000W

1920/1500W

Figure 23. Network Transient Protector

Dell UPS Management Software

Each Dell Tower UPS ships with Dell UPS Management Software.

Dell UPS Management Software provides up-to-date graphics of UPS power and system data and power

flow. It also gives you a complete record of critical power events, and it notifies you of important UPS or

power information. If there is a power outage and the Dell Tower UPS battery power becomes low, the

software can automatically shut down your computer system to protect your data before the UPS

shutdown occurs.

For details on disabling control commands from the software, see the user setting for Control

Commands from Serial Port setting on page 37.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 62 63

No comments

Dell UPS 500T User Manual Page 49