Dell PowerEdge T610 User Manual download pdf (Page 130)

130 Installing System Components

Install the expansion card stabilizer. See "Installing the Expansion Card

Stabilizer."

Close the system. See "Closing the System."

Place the system upright and on its feet on a flat, stable surface.

Reattach any peripherals, then connect the system to the electrical outlet.

Turn on the system and attached peripherals.

Press <F2> to enter the System Setup program, and check the

System

Memory

setting on the main System Setup screen.

The system should have already changed the value to reflect the newly

installed memory.

If the value is incorrect, one or more of the memory modules may not be

installed properly. Repeat step 5 through step 8 of this procedure, checking

to ensure that the memory modules are firmly seated in their sockets.

Run the system memory test in the system diagnostics. See "Running the

System Diagnostics."

Removing Memory Modules

WARNING: The memory modules are hot to the touch for some time after the

system has been powered down. Allow time for the memory modules to cool

before handling them. Handle the memory modules by the card edges and avoid

touching the components on the memory module.

CAUTION: To ensure proper system cooling, memory-module blanks must be

installed in any memory socket that is not occupied. Install a memory-module

blank if you are removing a memory module and do not intend to install a

replacement.

Turn off the system, including any attached peripherals, and disconnect

the system from the electrical outlet and peripherals.

Open the system. See "Opening the System."

Remove the expansion card stabilizer. See "Removing the Expansion Card

Stabilizer."

Remove the cooling shroud. See "Removing the Cooling Shroud."

Locate the memory module sockets. See Figure 6-1.

book.book Page 130 Tuesday, September 15, 2009 10:08 AM

1 2 ... 125 126 127 128 129 130 131 132 133 134 135 ... 205 206

No comments

Dell PowerEdge T610 User Manual Page 130