Dell PowerEdge T610 User Manual download pdf (Page 25)

About Your System 25

Viewing Status Messages

If a system error occurs, the LCD screen will turn amber. Press the Select

button to view the list of errors or status messages. Use the left and right

buttons to highlight an error number, and press Select to view the error.

Removing LCD Status Messages

For faults associated with sensors, such as temperature, voltage, fans, and so

on, the LCD message is automatically removed when that sensor returns to a

normal state. For other faults, you must take action to remove the message

from the display:

• Clear the SEL — You can perform this task remotely, but you will lose the

event history for the system.

• Power cycle — Turn off the system and disconnect it from the electrical

outlet; wait approximately ten seconds, reconnect the power cable, and

restart the system.

NOTE: The following LCD status messages are displayed in the Simple format. See

“Setup Menu“ to select the format in which the messages are displayed.

Table 1-1. LCD Status Messages

Code Text Causes Corrective Actions

E1000 Failsafe

voltage error.

Contact

support.

Check the system event

log for critical failure

events.

Remove AC power to the

system for 10 seconds and

restart the system.

If the problem persists,

see "Getting Help."

E1114 Ambient Temp

exceeds

allowed range.

Ambient temperature has

a reached a point outside

of the allowed range.

See "Troubleshooting

System Cooling

Problems."

book.book Page 25 Tuesday, September 15, 2009 10:08 AM

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 205 206

No comments

Dell PowerEdge T610 User Manual Page 25