Dell W-7200 Installation Manual Page 10

  • Download
  • Add to my manuals
  • Print
  • Page
    / 32
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 9
10 | Dell PowerConnect W-7200 Controller Dell PowerConnect W-7200 Series Controller | Installation Guide
10GBase-X (SFP+) Ports
The W-7200 is equipped with 4 10GBase-X (SFP+) ports. These port are labeled as 2, 3, 4, and 5. These ports are
intended for use with Dell SFPs. SFPs are 10Gb hot-swappable, optical transceivers, which convert serial
electrical signals to external serial optical or electrical signals. The ports support dual speed (1GbE or 10GbE)
operation.
10GBase-X Port LEDs
Each 10GBase-X port is equipped two LEDs that allow you to monitor the status of and activity on the port.
These LEDs provide basic monitoring of the status, activity, and basic configuration of each port. The
information displayed by these LEDs can be changed via the LCD.
LINK/ACT: on the left side of the port, displays the link status of the port.
Status: on the right side of the port, displays the status of the port. The information displayed by this LED
changes based on LCD’s mode. The LED behavior for each mode is described in Table 6.
Table 5
1000Base-X Port LEDs
LED Function LCD Mode Indicator Status
LINK/ACT Link status N/A Green (Solid) Link has been established
Green (Blinking) Port is transmitting or
receiving data
Off No link
Status Port status Administrative Green (Solid) Port Enabled
Off Port Administratively
Disabled
Duplex Green (Solid) Full-duplex
Off Half-duplex
Speed Green (Solid) 1 Gbps
Off Speed mismatch
NOTE: Dell tests and supports optics offered through Dell W-Series products within Dell controller systems. Third party optics are
not tested or supported; therefore, Dell does not guarantee proper functionality of third party optics when used in a Dell controller.
Table 6
10GBase-X Port LEDs
LED Function LCD Mode Indicator Status
LINK/ACT Link status N/A Green (Solid) Link has been established
Green (Blinking) Port is transmitting or
receiving data
Off No link
Page view 9
1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

Comments to this Manuals

No comments