Dell W-7200 Installation Manual download pdf (Page 24)

24 |Installation Dell PowerConnect W-7200 Series Controller | Installation Guide

6. Leave additional space in front and back of the unit to access power cords, network cables, the LCD panel,

and LED status indicators

Table or Shelf Installation

Required Tools and Equipment

 Rubber Feet (included)

Installation Steps

1. Attach the included rubber feet to the bottom of the controller.

2. Place your controller in the location you have chosen.

3. Connect the AC power cord to the rear of the unit.

4. Plug the opposite end of the power cord into an electrical outlet to power the controller.

Connecting the AC Power Cord

Once you have installed the W-7200 controller, you are ready to power on the device. The W-7200 controller is

not equipped with an On/Off switch. The device will turn on when the AC power cord has been connected to the

power supply module and an AC power outlet.

To connect the AC power cord:

1. Ensure that the power supply module is correctly installed in the W-7200 controller.

2. Lift the power cord retaining clip so it is not blocking the AC power connector.

3. Insert the coupler end of the AC power cord into the AC power connector on the power supply module.

4. Lower the power cord retaining clip over the AC power cord.

The W-7200 controller should now be receiving power. Since the W-7200 controller does not have an On/Off

switch, you must use the power cord to turn the device on or off. To turn the device off:

1. Lift the power cord retaining clip off the AC power cord.

2. Pull the AC power cord from the power supply module.

Installing and Removing a Fan Tray

The fan tray is field-replaceable and hot-swappable. Hot-swapping allows you to replace the fan tray without

having to power down the W-7200 controller.

1. Remove the old fan tray.

a. Using a Phillips Head screwdriver, turn the hinged captive screws counter-clockwise until loose (they

cannot be removed completely).

b. Firmly grasp both of the hinged captive screws and pull the spring loaded hinge down until you are sure

the hinges are disengaged. Use the fan tray handle to pull the fan out.

NOTE: Use standard ESD precautions when installing or removing a fan tray module.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

No comments

Dell W-7200 Installation Manual Page 24