Dell GX1 User Manual download pdf (Page 56)

2-22 Dell OptiPlex GX1 and GX1p Mini Tower Managed PC Systems Reference and Installation Guide

 5HFRQQHFW\RXUF RPSXWHUDQGSHULSKHUDOVWRW KHLUSRZHUVRXUFHVDQG

WKHQWXUQWKHPRQ

Booting your system with the PSWD jumper plug removed erases the existing

password(s).

 ( QWHUWKH6\VWHP6HWX SSURJUDPDQGYHULI\ WKDWWKHSDVVZRUGLVGLV

DEOHG3URF HHGWRVWHSLI\RXZDQWWRDVVLJQDQHZSDVVZRUG

NOTE: Before you assign a new system and/or setup password, you must

replace the PSWD jumper plug.

&$87,216HH´3URWHFWLQJ$JDLQVW(OHFWURVWDWLF'LVFKDUJHµLQWKHVDIHW\

LQVW UXFWLR QVDWWKHIURQWR IWKLVJXLGH

 5HPRYHWKHFRPSXWHUFRYHUDFFRUGLQJWRWKHLQVWUXFWLRQVLQ´5HPRYLQJ

W KH&R PSXWHU&RYHUµLQ&KDSWHU

 5HSODFHWKH3 6:'MXPSHUSOXJ

 5 HSODFHWKHF RPSXWHUFRYHUDQGWKHQUHFRQQHFWWKHFRPSXWHUDQG

SHULSKHUDOVWRWKHLUSRZHUVRXUFHVDQGWXUQWKHPRQ

Booting with the PSWD jumper installed reenables the password feature. When

you enter the System Setup program, both password options appear as Not

Enabled, meaning that the password feature is enabled but that no password has

been assigned.

  $VVLJQDQHZV\VWHPDQGRUVHWXSSDVVZ RUG

To assign a new system password, see “Assigning a System Password” found

earlier in this chapter. To assign a new setup password, see “Assigning a Setup

Password” found earlier in this chapter.

5HVSRQGLQJWR(UURU0HVVDJHV

If an error message appears on your monitor screen while the system is booting,

make note of the message. Then, before entering the System Setup program, refer to

your

Diagnostics and Troubleshooting Guide

for an explanation of the message and

suggestions for correcting any errors. However, it is normal to receive an error mes-

sage the first time you boot the system after a memory upgrade. In that case, you do

not need to refer to the

Diagnostics and Troubleshooting Guide

; instead, refer to the

instructions in “Adding Memory” in Chapter 6 of this guide.

If you are given an option of pressing either <F1> to continue or <F2> to run the Sys-

tem Setup program, press the <F2> key.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 173 174

No comments

Dell GX1 User Manual Page 56