Dell POWEREDGE 1950 User Manual download pdf (Page 34)

32 Two-Post Rack Installation

Installing the Mounting Rails

You can install the mounting rails in a two-post, open-frame rack having either universal-hole spacing (see

Figure 2-2) or wide-hole spacing (see Figure 2-3). You can install the mounting rails in either a flush-mount

or center-mount configuration.

CAUTION: Do not install another system using this rack kit. Use only the rack kit intended for your system. Using

the rack kit for another system may result in damage to the system and personal injury to yourself and to others.

Center-Mount Installation

The two-post rack kit is shipped with the brackets configured for a 7.62-cm (3-inch) wide center-mount

installation. See Figure 2-1 for mounting rail components. To complete the installation, perform the

following steps:

Locate the right mounting rail and push the adjustable mounting bracket toward the back of the

mounting rail (see Figure 2-4).

Position the right mounting rail in the two-post rack at the location you marked, push the center-

mount adjustable mounting bracket forward against the vertical two-post rack, and secure the

mounting flange and adjustable mounting bracket to the rack with four 12-24 x 0.5-inch pan-head

Phillips screws (see Figure 2-4).

Repeat step 1 and step 2 to install the left mounting rail in the rack.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 201 202

No comments

Dell POWEREDGE 1950 User Manual Page 34