Dell Inspiron 9200 User Manual download pdf (Page 52)



5. Remove the eight M2 x 3-mm screws from each side of the display panel.



6. Lift the display panel out of the display cover.



7. Press in both sides of the top flex-cable connector, and pull the top flex-cable connector away from the display connector.



8. Use the pull-tab to disconnect the bottom flex-cable connector from the inverter connector.



Replacing the Display Panel



1. Reconnect the top display cable connector to the top flex-cable connector.



2. Reconnect the bottom flex-cable connector to the inverter connector.



3. Replace the display panel inside the top cover.



4. Replace the M2 x 3-mm ground screw that attaches the display-panel ground wire to the back display cover.



5. Replace the eight M2 x 3 screws (four on each side) around the display panel.



6. Replace the display bezel.

Display Latch



Removing the Display Latch



1. Follow the instructions in "Before Working Inside Your Computer."



2. Remove the display.



3. Remove the display bezel.



pull-tab on bottom flex-cable connector

top flex-cable connector

display connector

inverter connector

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

NOTICE: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer.

NOTICE: To avoid damaging the system board, you must remove the main battery before you begin working inside the computer.

1 2 ... 47 48 49 50 51 52 53 54 55

No comments

Dell Inspiron 9200 User Manual Page 52