Dell T110 II Owner's Manual Page 41
- Page / 142
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Using the System Setup Program and UEFI Boot Manager 41
Boot Settings Screen
Integrated Devices Screen
Port D
(Off default)
Auto enables BIOS support for the device attached to
SATA port C. Off disables BIOS support for the device.
Port E
(Auto default)
Auto enables BIOS support for the device attached to
SATA port C. Off disables BIOS support for the device.
eSATA port
(Auto default)
Auto enables BIOS support for the device attached to the
eSATA port. Off disables BIOS support for the device.
Option Description
Boot Mode
(BIOS default)
CAUTION: Switching the boot mode could prevent
the system from booting if the operating system was
not installed in the same boot mode.
If the operating system supports Unified Extensible
Firmware Interface, you can set this option to UEFI.
Setting this field to BIOS allows compatibility with non-
UEFI operating systems.
NOTE: Setting this field to UEFI disables the Boot
Sequence, Hard-Disk Drive Sequence, and USB Flash Drive
Emulation Type fields.
Boot Sequence Retry
(Disabled default)
If this field is enabled and the system has failed to boot,
the system will reattempt to boot after 30 seconds.
Option Description
User Accessible
USB Ports
(All Ports On default)
Enables or disables the user-accessible USB ports.
Options are All Ports On, Only Back Ports On, and All
Ports Off.
Internal USB Port
(On default)
Enables or disables the internal USB port.
Embedded NIC1 and
NIC2
(Enabled default)
Enables or disables the operating system interface of the
NIC1 and NIC2 controllers. (The NICs may also be
accessed through the system’s management controller).
Option Description
Coaster_HOM.book Page 41 Monday, November 3, 2014 3:23 PM
- Owner’s Manual 1
- Notes, Cautions, and Warnings 2
- Contents 3
- 4 Contents 4
- 6 Contents 6
- 8 Contents 8
- Contents 9 9
- 10 Contents 10
- About Your System 11
- 12 About Your System 12
- 14 About Your System 14
- NIC Indicator Codes 16
- Diagnostic Lights 17
- 18 About Your System 18
- System Messages 19
- 20 About Your System 20
- 22 About Your System 22
- 24 About Your System 24
- MEMTEST lane 24
- 26 About Your System 26
- 30 About Your System 30
- Glossary 31
- Warning Messages 32
- Diagnostics Messages 32
- Alert Messages 32
- About Your System 33 33
- 34 About Your System 34
- Choosing the System Boot Mode 35
- Responding to Error Messages 36
- System Setup Options 37
- Memory Settings Screen 39
- Processor Settings Screen 39
- SATA Settings Screen 40
- Boot Settings Screen 41
- Integrated Devices Screen 41
- PCI IRQ Assignments Screen 42
- Serial Communication Screen 43
- Power Management Screen 44
- System Security Screen 45
- Exit Screen 47
- UEFI Boot Manager Screen 48
- UEFI Boot Settings Screen 48
- System Utilities Screen 49
- Using the System Password 49
- Using the Setup Password 52
- Embedded System Management 53
- Entering the BMC Setup Module 54
- Inside the System 58
- Opening the System 59
- Closing the System 60
- Front Bezel 61
- Installing the Front Bezel 62
- Removing Front Bezel Insert 62
- EMI Filler Panel 63
- 1 shoulder screws (3)* 69
- Hard Drives 70
- Expansion-Card Stabilizer 78
- Cooling Shroud 78
- Removing the Cooling Shroud 79
- Installing the Cooling Shroud 80
- Expansion Cards 81
- Removing an Expansion Card 82
- Installing an Expansion Card 84
- SAS Controller Expansion Card 85
- System Memory 86
- Removing Memory Modules 88
- Installing Memory Modules 89
- Processor 91
- Installing a Processor 94
- Cooling Fan 95
- Installing the Cooling Fan 96
- System Battery 97
- Power Supply 99
- Installing the Power Supply 100
- Internal USB Memory Key 101
- Chassis Intrusion Switch 102
- Control Panel Assembly 104
- System Board 107
- Installing the System Board 109
- Installing System Components 110
- Troubleshooting Your System 111
- Troubleshooting a USB Device 112
- Troubleshooting a NIC 113
- Troubleshooting a Wet System 114
- Troubleshooting Power Supply 117
- Troubleshooting Cooling Fan 118
- Troubleshooting System Memory 119
- Troubleshooting a Hard Drive 123
- Troubleshooting the Processor 125
- Using Online Diagnostics 127
- Using the Custom Test Options 129
- Jumpers and Connectors 131
- System Board Connectors 132
- Getting Help 135
- 136 Getting Help 136
- Numerics 137
- Index 139 139
- Index 141 141
- 142 Index 142
Related products and manuals for Servers Dell T110 II
Servers Dell R210 II Specifications
(67 pages)
(67 pages)
Servers Dell T420 Manual
(27 pages)
(27 pages)
Servers Dell PowerEdge T110 II Owner's Manual
(130 pages)
(130 pages)
Servers Dell T420 Specifications
(53 pages)
(53 pages)
Servers Dell R930 Owner's Manual
(177 pages)
(177 pages)
Servers Dell R220 Specifications
(48 pages)
(48 pages)
Servers Dell R520 Specifications
(51 pages)
(51 pages)
Servers Dell T420 Specifications
(52 pages)
(52 pages)
Servers Dell R520 Owner's Manual
(141 pages)
(141 pages)
Servers Dell R210 II Specifications
(57 pages)
(57 pages)
Servers Dell T20 Specifications
(29 pages)
(29 pages)
Servers Dell R720 Specifications
(65 pages)
(65 pages)
Servers Dell T20 Specifications
(30 pages)
(30 pages)
Servers Dell R210 II Owner's Manual
(144 pages)
(144 pages)
Servers Dell PowerEdge R610 Specifications
(56 pages)
(56 pages)
Servers Dell R530 Owner's Manual
(154 pages)
(154 pages)
Servers Dell R320 Specifications
(51 pages)
(51 pages)
Servers Dell R420 Owner's Manual
(145 pages)
(145 pages)
Servers Dell R320 Specifications
(50 pages)
(50 pages)
Servers Dell PowerEdge R410 Specifications
(58 pages)
(58 pages)
© 2020, manymanuals.com. All rights reserved. | 1.601 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals