Dell PowerEdge 1800 User Manual download pdf (Page 2)

www.dell.com | support.dell.com

Insert the card-edge connector firmly into the system-board card connector until the card

is fully seated.

NOTE: Some systems use a plastic bar to secure the expansion-card bracket to the back panel

instead of a screw.

Install the screw that secures the expansion-card bracket to the back panel.

Close the system. See "Closing the System" in the

Installation and Troubleshooting Guide

for

instructions.

Figure 1. Installing the DRAC 4/P Card

Connect the monitor cable to the card video connector on the DRAC 4/P card. See Figure 2.

The monitor cable must be connected to the card video connector on the DRAC 4/P card—

not to the system’s integrated video connector.

Connect the network to the card NIC connector on the DRAC 4/P card. See Figure 2.

The network cable must be connected to the card NIC connector on the DRAC 4/P card—

not to the system’s integrated NIC connector.

Reattach the system to its AC power source and turn on the system.

DRAC 4/P card

system-

board card

connector

screw

expansion-card bracket

expansion

slot

interface cable

RAC connector

card-interface

connector

card-edge

connector

The connectors on your system board and the actual

expansion slot that you use may vary on your system board.

1 2 3 4 5 6 7 ... 27 28

No comments

Dell PowerEdge 1800 User Manual Page 2