Dell PowerEdge C8000 User Manual Page 266
- Page / 294
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
266 Troubleshooting
Fresh air
mode
Upper
non-recoverable
52 °C
(125.6 °F)
Extremely high Fan controller (FC)
firmware shuts down the
system.
NOTE: The firmware reads
inlet temperature every 5 secs.
If the inlet temperature reaches
non-recoverable threshold, the
firmware will start to check the
power status for each sled and
initiate the sled for graceful
shutdown (pull-low 4 seconds).
Upper critical 50 °C
(122 °F)
High Chassis status indicator
lights amber.
Upper
non-critical
48 °C
(118.4
°F)
Warning Temperature events are
recorded in the SEL.
Table 5-6. Enclosure Air Inlet Temperature Threshold Settings
(continued)
Enclosure
Inlet
Condition
Threshold
Setting
Ambient
Temp
Threshold Level Action
- Hardware Owner’s 1
- Notes, Cautions, and Warnings 2
- Contents 3
- 4 Contents 4
- 6 Contents 6
- 8 Contents 8
- 6 Updating Firmware Images 9
- 10 Contents 10
- About the System 11
- 12 About the System 12
- 14 About the System 14
- 16 About the System 16
- 18 About the System 18
- NIC Indicator Codes 20
- Sled Bay Numbering 22
- Fan Bay Numbering 23
- Sled Module Configuration 24
- About the System 25 25
- Sled Features 26
- 28 About the System 28
- Double-Wide Compute Sled 29
- 30 About the System 30
- 32 About the System 32
- Storage Sleds 34
- Power Sleds 36
- Service Tag 38
- About the System 39 39
- (4-Drive Bay) Hard-Drives 39
- (8-Drive Bay) Hard-Drives 39
- 40 About the System 40
- POST Error Codes 41
- 42 About the System 42
- 44 About the System 44
- 46 About the System 46
- 48 About the System 48
- System Event Log 49
- Memory Ecc 50
- PCIe Error 52
- IOH Core Error 53
- SB Error 54
- POST Start Event 55
- POST End Event 56
- POST Error Code Event 57
- BIOS Recovery Event 58
- ME Fail Event 58
- SEL Generator ID 59
- • SI = Sensor Initialization 60
- 62 About the System 62
- 43h DIMM ZONE 1 63
- 64 About the System 64
- 66 About the System 66
- System Setup Menu 67
- System Setup Options at Boot 68
- General Help 69
- Console Redirection 69
- Serial Port Connection List 73
- Main Menu 74
- System Settings 75
- Advanced Menu 77
- Power Management 78
- Chassis Power Management 80
- Chassis PSU Configuration 82
- Power Capping 84
- Emergency Throttling 87
- CPU Configuration 88
- Prefetch Configuration 91
- Memory Configuration 92
- SATA Configuration 95
- PCI Configuration 98
- Embedded Network Devices 100
- PCI Slot Configuration 104
- USB Configuration 105
- Security Menu 107
- Server Menu 109
- Set BMC LAN Configuration 111
- IPv6 Mode 112
- Remote Access Configuration 113
- View System Log 115
- Boot Menu 116
- Exit Menu 118
- (continued) 121
- IPMI Command List 146
- (continued) 148
- Power Management Settings 155
- About MIB and Traps 157
- FCB Configuration Information 158
- FCB Firmware Behavior 159
- MIB Tree Diagram for FCB 161
- FCB SNMP MIB 162
- Table 2-22. FCB SNMP MIB 163
- PMC Network Connection 168
- PMC Configuration Information 169
- PMC Firmware Behavior 170
- MIB Tree Diagram for PMC 171
- PMC SNMP MIB 172
- Table 2-24. PMC SNMP MIB 173
- Installing System Components 187
- About the Illustrations 188
- Recommended Tools 188
- Inside the System 189
- Sled Blank 190
- Compute Sleds 192
- 1 release latch 2 handle 193
- Storage Sled 194
- Installing a Storage Sled 195
- Power Sled 196
- Inside a Power Sled 198
- Removing a Power Sled 198
- Installing a Power Sled 200
- Removing the PSU Module 205
- Installing the PSU Module 206
- Fan Modules 207
- Installing a Fan Module 208
- Front Panel Board 209
- Fan Controller Board 211
- Backplane/Fan Bay Cage 212
- 1 screws (4) 2 fan bay cage 213
- Power Source 214
- PDU Power Supply 217
- 1 power cable 2 release latch 218
- Installing a PDU Power Supply 219
- Rack Mount Configuration 221
- Installation Tasks 222
- Rack Mount Configuration 225 225
- 3 rack post 225
- 226 Rack Mount Configuration 226
- Enclosure 228
- Rack Mount Configuration 229 229
- 1 10-32 screws (4) 230
- OFFOFFOFF 231
- See Figure 4-11 235
- 236 Rack Mount Configuration 236
- Connecting the Power Cables 237
- 242 Rack Mount Configuration 242
- 3 PDU device 244
- Rack Mount Configuration 245 245
- 1 NIC port 1 2 network cable 245
- Powering Up the Systems 246
- 250 Rack Mount Configuration 250
- Troubleshooting 251
- Troubleshooting a USB Device 252
- Troubleshooting 253 253
- Troubleshooting a NIC 254
- Fan Module 257
- Troubleshooting 259 259
- Table 5-3. Case Scenario 2 259
- Table 5-4. Case Scenario 3 259
- Table 5-5. Case Scenario 4 260
- Troubleshooting 261 261
- Troubleshooting 263 263
- 266 Troubleshooting 266
- NOTE: The firmware reads 266
- Troubleshooting System Memory 267
- Troubleshooting a Hard-Drive 269
- Troubleshooting Processors 270
- IRQ Assignment Conflicts 273
- 274 Troubleshooting 274
- Updating Firmware Images and 275
- Firmware Via SNMP 276
- Checking FCB Indicators 277
- Configuring the SNMP Traps 278
- Updating the FCB Firmware 279
- Updating the PDU PMC Firmware 280
- Checking PDU Indicators 281
- Updating the PMC Firmware 283
- Jumpers and Connectors 285
- 286 Jumpers and Connectors 286
- 288 Jumpers and Connectors 288
- Getting Help 289
- 290 Getting Help 290
- Index 291 291
- Index 293 293
- Index 294 294
Related products and manuals for Computer hardware Dell PowerEdge C8000
(28 pages)
Computer hardware Dell UPS 1000R User Manual
(20 pages)
(20 pages)
© 2020, manymanuals.com. All rights reserved. | 1.345 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals