Dell Dimension XPS T___ User Manual download pdf (Page 11)

Back to Contents Page

EIDESubsystem:Dell™Dimension™XPST

xxx

and T

xxx

r Systems Reference

The enhanced integrated drive electronics (EIDE) subsystem includes 2 EIDE interfaces (primary and secondary), each of which can support up to

2 EIDE devices such as high-capacity EIDE hard-disk drives, CD-ROM drives, and tape drives.

Configure all EIDE devices for the Cable Select jumper position, which assigns master and slave status to devices by their position on the

interface cable. In this configuration, the drive attached to the last connector on the interface cable is the master or boot drive (drive 0) and the

drive attached to the middle connector on the interface cable is the slave drive (drive 1). Refer to the drive’s documentation for instructions on

setting the Cable Select jumper position.

When you replace a drive, refer to the jumpers on the original drive to set the jumpers on the replacement drive.

Back to Contents Page

NOTE: The externally accessible drive bays at the front of the system are normally used for diskette drives, CD-ROM drives, or tape

drives.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 52 53

No comments

Dell Dimension XPS T___ User Manual Page 11