Dell Dimension XPS T___ User Manual download pdf (Page 20)

Secondary Hard-Disk Drive

To remove the secondary hard-disk drive, perform the following steps:

1. Remove the bezel.

2. Disconnect the DC power and interface cables from the back of the drive.

3. Remove the two drive-assembly mounting screws.

4. Slide the hard-disk drive assembly toward the back of the chassis and lift it out.

5. Remove the drive from the drive bracket by removing the screw securing the drive to the bracket, and rotating the drive out of the bracket.



When you replace a hard-disk drive, set the jumpers on the replacement drive to match the jumpers on the drive you removed. For additional

information about jumper settings on EIDE drives, see EIDE Subsystem.

As you insert the replacement hard-disk drive into the drive bracket, make sure that the two bracket tabs fit into the mounting holes on the side of

the drive.

Secondary hard-disk drive assembly

Card guide assembly

Drive-assembly mounting screws (2)

Screw

Drive bracket

Tabs (2)

Secondary hard-disk drive

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 52 53

No comments

Dell Dimension XPS T___ User Manual Page 20