Dell OptiPlex G1 User Manual download pdf (Page 28)

Removing and Replacing Parts: Dell OptiPlex GX1 Systems Service Manual

file:///C|/infodev/2013/eDoc/OpGX1/SM/remsff.htm[2/21/2013 11:45:32 AM]

CAUTION: There is a danger of the new battery exploding if it is incorrectly installed. Replace

the battery only with the same or equivalent type recommended by the manufacturer. Discard

used batteries according to the manufacturer’s instructions.

To remove the system battery, perform the following steps:

1. If possible, enter the System Setup program and print the System Setup screens.

2. Remove the system battery by carefully prying it out of its socket with your fingers or with a blunt,

nonconducting object such as a plastic screwdriver.

When you replace the system battery, orient the new battery with the "+" facing up. Insert the battery into its

socket and snap it into place.

System Board

Figure 30. System Board Removal

To remove the system board, perform the following steps:

1. Disconnect all cables from their connectors at the back of the computer.

2. Remove the drive shelf assembly

3. Remove the expansion-card cage.

4. Remove the hard-disk drive/bracket.

5. Disconnect all cables from the system board.

6. Remove the screw that secures the system board to the bottom of the chassis (see Figure 30).

7. Slide the system board toward the front of the chassis until it stops.

1 2 ... 23 24 25 26 27 28 29

No comments

Dell OptiPlex G1 User Manual Page 28