Dell PowerEdge 800 Service Manual download pdf (Page 11)

Back to Contents Page

 Service-Only Parts Replacement Procedures

Dell™PowerEdge™800SystemsInstallationandTroubleshootingGuide

Recommended Tools

Control Panel Assembly

Chassis-Intrusion Switch

System Board

Recommended Tools

You may need the following items to perform the procedures in this section:

l Key to the system keylock

l Wrist grounding strap

l #2 Phillips screwdriver

Control Panel Assembly



Removing the Control Panel Assembly



1. Turn off the system and attached peripherals, and disconnect the system from the electrical outlet.



2. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."



3. Lay the system on its right side.



4. Remove the cover. See "Removing the Cover" in "Troubleshooting Your System."



5. Disconnect the control panel assembly cable from the FRONT_PANEL connector on the system board. See FigureA-3.



6. Using a #2 Phillips screwdriver, remove the two mounting screws that secure the control panel assembly to the chassis. See FigureC-1.



7. Lift the control panel assembly and its cable away from the system. See FigureC-1.

Figure C-1. Removing the Control Panel Assembly



Installing the Control Panel Assembly



CAUTION: See your Product Information Guide for complete information about safety precautions, working inside the computer, and protecting

against electrostatic discharge.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 86 87

No comments

Dell PowerEdge 800 Service Manual Page 11