Dell PowerEdge 800 Service Manual download pdf (Page 72)



Removing a Front-Access SCSI Hard Drive (Non-Hot-Plug)



1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.



2. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."



3. Open the hard-drive carrier handle to release the drive. See Figure7-11.



4. Slide the hard drive out until it is free of the drive bay.

Figure 7-11. Removing or Installing a SCSI Hard-Drive Carrier



Installing a Front-Access SCSI Hard Drive (Non-Hot-Plug)



1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet.



2. Remove the bezel. See "Removing the Bezel" in "Troubleshooting Your System."



3. Open the hard-drive carrier handle. See Figure7-11.



NOTICE: To prevent data loss, you must shut down the system before removing a SCSI drive carrier, unless a SCSI RAID controller is connected to the

SCSI backplane. See "Hot-Plug SCSI Hard Drives" for information on hot-plug drive requirements and operation.

NOTICE: Do not insert a hard-drive carrier and attempt to lock its handle next to a partially installed carrier. Doing so can damage the partially installed

carrier's shield spring and make it unusable. Ensure that the adjacent drive carrier is fully installed.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 86 87

Comments to this Manuals

No comments

Dell PowerEdge 800 Service Manual Page 72

Comments to this Manuals

Related products and manuals for Servers Dell PowerEdge 800