Dell POWEREDGE M1000E User Manual download pdf (Page 35)

M5424 SAN I/O Module Hardware Reference Manual 25

53-1001082-01

Appendix

SAN I/O Module specifications

This appendix provides product specifications and regulatory compliance as a handy reference.

Access Gateway Mode default port mapping

The M5424 SAN I/O Module can contain 24 total ports. Of these, F_Ports are ports 1-16 and

N_Ports are ports 0 and 17-23.

In Access Gateway mode, the SAN I/O Module F_Ports are mapped to N_Ports. This following lists

the factory-default F_Port to N_Port mapping for Access Gateway mode. Since the SAN I/O Module

is shipped with Dynamic Ports on Demand (DPOD) enabled, any out of the 24 ports can be

enabled. Therefore this mapping applies for 12 active ports or, if POD licensing is enabled, for 24

ports. For more information on changing port mapping and managing ports in Access Gateway

Mode, refer to the Access Gateway Administrator’s Guide.

• 17-20 as N_Port with failover enabled, failback enabled

• 0, 21-23 as N_Port with failover enabled, failback enabled

• 1, 2 mapped to 17

• 3, 4 mapped to 18

• 5, 6 mapped to 19·

• 7, 8 mapped to 20

• 9, 10 mapped to 21·

• 11, 12 mapped to 22·

• 13, 14 mapped to 23·

• 15, 16 mapped to 0

Processor and memory specifications

The processor and memory installed in the SAN I/O Module are shown in Table 5.

TABLE 5 Memory Specifications

Memory Type Value

PowerPC 440EPX processor 667 MHz

SDRAM 512 MB DDR2 - for system memory at 64 bits

wide with 8 ECC operating at 166 MHz

Boot flash 4 MB

Compact flash 512 MB

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

No comments

Dell POWEREDGE M1000E User Manual Page 35