Dell PowerEdge R905 Owner's Manual download pdf (Page 109)

Installing System Components 109

When you format a high-capacity hard drive, allow enough time for the

formatting to be completed. Long format times for these drives are normal.

Configuring the Boot Device

If you plan to boot the system from a hard drive, the drive must be attached

to the primary (or boot) controller. The device that the system boots from is

determined by the boot order specified in the System Setup program.

The System Setup program provides options that the system uses to scan for

installed boot devices. See "Using the System Setup Program" on page 45 for

information about the System Setup program.

Removing a Drive Blank

NOTICE: To maintain proper system cooling, all empty hard-drive bays must have

drive blanks installed. If you remove a hard-drive carrier from the system and do not

reinstall it, you must replace the carrier with a drive blank.

Remove the bezel. See "Removing and Replacing the Optional Front

Bezel" on page 66.

Insert your finger under the shrouded end of the blank and press in on the

latch to eject the blank outward from the bay.

Pry the ends of the blank outward until the blank is free.

Installing a Drive Blank

The drive blank is keyed to ensure correct insertion into the drive bay. To

install a drive blank, insert and rotate in the keyed side of the blank into the

drive bay and press evenly on the other end of the blank until it is fully

inserted and latched.

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 201 202

No comments

Dell PowerEdge R905 Owner's Manual Page 109