Back to Contents Page
InstallingtheAutoloader:Dell™PowerVault™124TLTO3-060 Autoloader User's
Guide
Installation Overview
Installing the autoloader consists of the following steps, which are explained in more detail later in this section:
1. Prepare to install your new Dell PowerVault 124T LTO3-060 autoloader (see "Installation Preparation").
2. Identify the proper SCSI bus types (see "SCSI Bus Requirements").
3. Identify the accessories that come with the autoloader (see "Accessories").
4. Install the autoloader in a computer rack near the host server. If installing a rack mount unit, refer to your rack Installation Guide.
5. Shut down or turn off the server and all devices attached to the server (see "Connecting the SCSI and Power Cables").
6. Attach the SCSI cable to the autoloader and server's SCSI host adapter (see "Connecting the SCSI and Power Cables").
7. Attach the power cable to the autoloader and plug in the power cable to the nearest power outlet (see "Connecting the SCSI and Power Cables").
Power the autoloader on to ensure it passes the Power-on Self-Test (POST).
8. Set the SCSI ID for the autoloader (see "Setting the SCSI ID").
9. Set up the host and verify the connection (see "Preparing the Host and Verifying the Connection").
Installation Preparation
Before you install your new Dell PowerVault 124T LTO3-060 autoloader, unpack it carefully and inspect it for any damage that might have occurred during
shipping. The Getting Started Guide included in the packaging describes all the necessary information to unpack and inspect your autoloader correctly. Locate
the Getting Started Guide and follow the directions.
Ensure that the work area is free from conditions that could cause electrostatic discharge (ESD). Discharge static electricity from your body by touching a
known grounded surface, such as your computer's metal chassis.
SCSI Bus Requirements
You must connect the Dell PowerVault 124T LTO3-060 autoloader to one of the following SCSI bus types:
l Ultra 160 SCSI, Low-voltage Differential (LVD)
l Ultra 320 SCSI, Low-voltage Differential (LVD)
l Single-ended (SE) SCSI bus
Your SCSI host adapter card must also support the SCSI bus type used to connect the autoloader. If you use a LVD SCSI bus, use a host adapter card with a
connection for a high-density (HD) 68-pin cable.
Accessories
The following accessories are shipped with the Dell PowerVault 124T LTO3-060 autoloader:
l Getting Started Guide
l SCSI host cable
l SCSI terminator
l Hardware to rack mount the autoloader (autoloader rails are included, rack rails are optional)
l One magazine blank
Comments to this Manuals