Dell PowerVault TL4000 User Manual Page 5
- Page / 306
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Read this first
Minimum firmware levels for common library features
Table 1. Minimum firmware levels for common library features
Feature Minimum Firmware Level(s) Required
LTO HH V2 Tape Drives Library firmware level must be at A.00, or
greater, to support HH V2 Tape Drives.
LTO 6 Tape Drive Library firmware must be at B.50 or greater
to support the Ultrium 6 drives. Ensure the
minimum version required to support
Ultrium 6 tape drives are installed on the
host. Ensure that any host applications and
software using their own device drivers are
at the minimum level required to support
Ultrium 6 tape drives.
LTO 5 Tape Drive Library firmware must be at 9.00, or greater,
to support the Ultrium 5 drives. Ensure the
minimum version required to support
Ultrium 5 tape drives are installed on the
host. Ensure that any host applications and
software using their own device drivers are
at the minimum level required to support
Ultrium 5 tape drives.
Library BCR (Bar Code Reader) Libraries manufactured after May 2010 may
have a BCR that requires a minimum level
of library firmware. The minimum level of
firmware for these libraries is 9.00. Attempts
to downlevel these libraries below 9.00 will
be blocked by the library.
Dedicated Cleaning Slot removal Library firmware level must be greater than
3.90.
Encryption Library firmware level must be 5.80 or
greater.
LTO4 Drive firmware level must be 77BE or
greater.
Key Path Diagnostics Library firmware level must be greater than
6.3, if feature is available.
Path Failover LTO 4 Tape Drives: No minimum level of
firmware is required.
IPv6 Support Library firmware level: 4.50
Contacting Dell
For customers in the United States, call 800-WWW-DELL (800-999-3355).
Note: If you do not have an active Internet connection, you can find contact
information about your purchase invoice, packing slip, bill, or Dell product
catalog.
iii
- User's Guide 1
- Read this first 5
- Contents 7
- Figures ix 11
- Danger and caution notices 15
- Laser Safety and Compliance 16
- Rack safety 17
- CAUTION: 18
- Related Publications 19
- Front Panel 21
- Rear Panel 23
- Bar Code Reader 25
- Encryption 25
- Supported Internet Protocols 27
- SNMP Messaging 27
- SNMP Traps 27
- Ultrium Tape Drives 29
- Speed Matching 30
- Channel Calibration 30
- Power Management 31
- Library Specifications 32
- Product Environment 34
- Supported Device Drivers 34
- Chapter 2. User Interfaces 35
- Power-ON Display 36
- Input Modes 37
- Power ON/OFF 38
- Web User Interface 38
- System Status 40
- Web User Interface Help Pages 42
- Basic Guidelines 43
- Library Sharing 43
- Using Multiple Control Paths 44
- Host Interfaces 49
- SCSI Interface 49
- Using Multiple SCSI Buses 50
- SAS Interface 51
- Fibre Channel Interface 52
- Installing Your Library 55
- Choosing a Location 55
- Unpacking the Library 56
- Verifying the shipment 56
- 2. Store the lock ( 59
- ) and label ( 59
- Figure 4-5 on page 4-6 59
- Connecting a Power Cord 72
- Configuring Your Library 73
- Item Default Setting 74
- Bar Code Label Length 8 74
- Library Mode Random 74
- AutoClean Disabled 74
- Verifying/Updating Firmware 77
- Setting Up Encryption 81
- Topology 84
- FC-AL Loop ID 84
- Figure 4-33. Warning Screen 86
- Interface 88
- Configuring SNMP settings 89
- Preparing the Host 91
- Verifying the Connection 92
- Cartridge magazines 92
- 2U Library I/O station 93
- 4U library I/O station 95
- Chapter 5. Operations 99
- Chapter 5. Operations 5-3 101
- Chapter 5. Operations 5-5 103
- Chapter 5. Operations 5-7 105
- Chapter 5. Operations 5-9 107
- Monitor Menu 108
- Assigned IPv6 109
- Note: This will display 109
- Config is enabled 109
- Monitor: Drive 110
- Fibre Channel Drive 111
- Monitor: Inventory 112
- Chapter 5. Operations 5-15 113
- Control Menu 114
- Control: Move Cartridges 115
- Control: Magazine 115
- Configure Menu 116
- Configure: Logical Libraries 117
- Configure: Library 118
- Chapter 5. Operations 5-21 119
- Configure: Drive 121
- DHCP-OFF 122
- (IPv4 & IPv4+IPv6) 122
- Configure: Set Access PIN 123
- Configure: Save/Restore 124
- Configure 125
- Save/Restore 125
- Service Menu 127
- Service: Run Tests 128
- Service: Service (Drives) 129
- Web User Interface Menus 130
- Monitor Library Menu 131
- Chapter 5. Operations 5-35 133
- Monitor Library: Drive Status 135
- Monitor Library: Inventory 137
- Drive Inventory 138
- Magazine Inventory 138
- Manage Library Menu 139
- Configure Library Menu 141
- Chapter 5. Operations 5-45 143
- Configure Library: Encryption 144
- Chapter 5. Operations 5-47 145
- Configure Library: Drives 146
- Chapter 5. Operations 5-49 147
- Configure Library: Network 148
- Chapter 5. Operations 5-51 149
- Figure 5-44. Warning Screen 150
- Chapter 5. Operations 5-53 151
- Chapter 5. Operations 5-55 153
- Configure Library: SNMP 154
- Chapter 5. Operations 5-57 155
- Service Library Menu 156
- Service Library: View Logs 157
- Chapter 5. Operations 5-61 159
- Chapter 5. Operations 5-63 161
- Service Library: Reboot 163
- Import Media 163
- Export Media 164
- Dedicated Cleaning Slot 165
- Reserving Slots 165
- Data Cartridges 167
- Cartridge Compatibility 169
- WORM Media 169
- Data Security on WORM Media 169
- WORM Media Errors 170
- Cleaning Cartridge 170
- Bar Code Label 170
- TO1 2 3 L6 172
- Handling the Cartridges 173
- Provide Training 173
- Ensure Proper Packaging 174
- Perform a Thorough Inspection 175
- Chapter 7. Troubleshooting 177
- Installation Problems 182
- Isolating Drive Sled Problems 185
- Chapter 8. Error codes 191
- Error codes 192
- Chapter 8. Error codes 8-3 193
- Chapter 8. Error codes 8-5 195
- Sub Error Codes 197
- Chapter 8. Error codes 8-9 199
- Chapter 8. Error codes 8-11 201
- Chapter 8. Error codes 8-13 203
- Chapter 9. Service Procedures 205
- Tools Required 211
- Electrostatic Discharge 211
- Relocating Your Library 211
- 1 Shipping Lock 212
- 2 Shipping Label 212
- Removing a Tape Drive Sled 214
- Installing a Tape Drive Sled 216
- 2ULibrary 4ULibrary 218
- Adding a Tape Drive Sled 219
- Replacing a Power Supply 220
- Replacing Cartridge Magazines 223
- Swapping Cartridge Magazines 232
- Enclosure 237
- Physical Configurations 239
- Partitioning of 2U Libraries 241
- Partitioning of 4U Libraries 241
- Mixing of Drives 242
- SCSI Element Addressing 244
- Appendix B. TapeAlert Flags 247
- Appendix C. Sense Data 253
- 30h 07h Cleaning failure 254
- Appendix C. Sense Data C-3 255
- Appendix C. Sense Data C-5 257
- Drive Sense Data 259
- Appendix C. Sense Data C-9 261
- Appendix C. Sense Data C-11 263
- Appendix C. Sense Data C-13 265
- Appendix C. Sense Data C-15 267
- Red Hat Enterprise Linux 270
- 2003/XP and 2008/Vista 273
- Windows 2008/Vista 274
- Appendix H. Accessibility 279
- Glossary 281
- Glossary I-3 283
- Glossary I-5 285
- Glossary I-7 287
- Glossary I-9 289
- Glossary I-11 291
- Glossary I-13 293
- Glossary I-15 295
- Glossary I-17 297
- Glossary I-19 299
- Printed in USA 306
Related products and manuals for Computer hardware Dell PowerVault TL4000
Computer hardware Dell PERC 4/SI User Manual
(76 pages)
(76 pages)
(14 pages)© 2020, manymanuals.com. All rights reserved. | 7.682 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals