Dell Dimension 5100C User Manual Page 104

  • Download
  • Add to my manuals
  • Print
  • Page
    / 128
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 103
104 Appendix
www.dell.com | support.dell.com
3
Replace the computer cover (see page 91).
4
Connect your computer and monitor to electrical outlets, and turn them on.
5
After the Microsoft
®
Windows
®
desktop appears on your computer, shut down the computer
(see page 53).
6
Turn off the monitor and disconnect it from the electrical outlet.
7
Disconnect the computer power cable from the electrical outlet, and press the power button
to ground the system board.
8
Remove the computer cover (see page 59).
9
Locate the 3-pin password jumper (PSWD) on the system board (see page 103) and attach
the jumper to pins 2 and 3 to re-enable the password feature.
10
Replace the computer cover (see page 91).
NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into
the computer.
11
Connect your computer and devices to electrical outlets, and turn them on.
Clearing CMOS Settings
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions
located in the Product Information Guide.
1
Follow the procedures in "Before You Begin" on page 53.
2
Reset the current CMOS settings:
a
Locate the 3-pin CMOS jumper (RTCRST) on the system board (see page 103).
b
Remove the jumper plug from pins 1 and 2.
c
Place the jumper plug on pins 2 and 3 and wait approximately 5 seconds.
d
Replace the jumper plug on pins 1 and 2.
3
Replace the computer cover (see page 91).
NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into
the computer.
4
Connect your computer and devices to electrical outlets, and turn them on.
Page view 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 127 128

Comments to this Manuals

No comments