Dell OptiPlex 760 User Manual download pdf (Page 115)

Back to Contents Page

Dell™OptiPlex™760ServiceManual

Heat Sink and Processor

Heat Sink and Processor



Removing the Processor



1. Follow the procedures in Working on Your Computer.



2. Remove the computer cover (see Removing the Computer Cover).



3. Remove the optical drive (see Optical Drive).



4. Loosen the captive screws on each side of the heat sink assembly.



5. Disconnect the floppy-drive data cable from the system board and release it from the securing tab on the heatsink (see Floppy Drive).



6. Rotate the heat sink assembly upward, and remove the assembly from the computer.

Lay the heat sink down on its top, with the thermal grease facing upward.



7. Open the processor cover by sliding the release lever from under the center cover latch on the socket. Then, pull the lever back to release the

processor.

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance

CAUTION: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of

your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis.

WARNING: Despite having a plastic shield, the heat sink assembly may be very hot during normal operation. Be sure that it has had sufficient

time to cool before you touch it.

heat sink assembly

captive screws in housing (2)

CAUTION: Unless a new heat sink is required for the new processor, reuse the original heat sink assembly when you replace the processor.

1 2 ... 110 111 112 113 114 115 116 117 118 119 120 ... 202 203

No comments

Dell OptiPlex 760 User Manual Page 115