Dell OptiPlex E1 User Manual download pdf (Page 63)

80 MB 16 MB 64 MB

128 MB 64 MB 64 MB

128 MB 128 MB

160 MB 128 MB 32 MB

192 MB 128 MB 64 MB

256 MB 128 MB 128 MB

Performing a Memory Upgrade

To perform a memory upgrade, follow these steps.

NOTE: After you remove and replace the cover in the following procedure, the chassis intrusion detector will cause the

following message to be displayed at the next system start-up:

ALERT! Cover was previously removed.

To reset the chassis intrusion detector, enter the System Setup program and reset Chassis Intrusion to Not Detected.

See "

Using the System Setup Program," for instructions. If a setup password has been assigned by someone else,

contact your network administrator for information on resetting the chassis intrusion detector.

1. Remove the computer cover according to the instructions in "

Removing the Computer Cover".

CAUTION: Turn off the computer and unplug it from the electrical outlet. See "Protecting Against

Electrostatic Discharge" in the safety instructions at the front of this guide.

2. Determine the DIMM sockets into which you will install DIMMs or replace existing DIMMs (see Figure 6-1).

3. Install or replace DIMMs as necessary to reach the desired memory total.

Follow the instructions in "

Installing a DIMM" or "Removing a DIMM," as appropriate, found later in this section.

4. Replace the computer cover, reconnect your computer and peripherals to their power sources, and turn them on.

After the system completes the power-on self-test (POST) routine, the system runs a memory test that displays the total

memory of all installed DIMMs, including those you just installed.

NOTES: If the memory total is incorrect, turn off your computer and peripherals and disconnect them from their

power sources, remove the computer cover, and make sure that the installed DIMMs are seated properly in their

sockets. Then repeat this step.

The system detects that the new memory does not match the existing system configuration information, which is

stored in nonvolatile random-access memory (NVRAM), and generates the following message:

The amount of system memory has changed.

Strike the F1 key to continue, F2 to run the setup utility

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 87 88

No comments

Dell OptiPlex E1 User Manual Page 63